Installation Guide

Page 4 of 4
www.generalspecialtiesmfg.com
208-265-5244
With your panels centered up and bolted to left and right rails, place the rail - panel assembly on your
mounting surface. Attach the feet to the mounting surface using bolts or lag screws in the 2 holes
punched in each foot. If
you want to tip the panel up, unbolt braces and rails from feet as shown
(the
rails will still be attached to the panel at this point).
Pick the tilt angle you desire, somewhere between the two angles shown. Place bolts in corresponding
holes and tighten. Make sure panel is held to bottom of rails to allow braces to clear panel in upright
configuration.