Installation Manual

Page 6 of 8
www.generalspecialtiesmfg.com
208-265-5244
Bracket orientation in most installations is generally opposed to one another as in top picture. It
may be necessary to have brackets facing in same direction as in bottom picture, if panel size is
such that you need to do this to maintain a ¼” gap between panel ends on centerline.
NOTE: Leave 5/16” serrated flange nuts slightly loose until all panels are attached and square to
one another. Then finish tightening the nuts.
UPM 10X and 10XHD
RAIL BRACKET LOCATION
INSTRUCTIONS
REVISION:
06.24.13
Serrated flange nut
Aluminum bracket
Universal aluminum T-
Slot extrusion panel
rails (as shown) or you
may have aluminum
angle with punched
holes.
Cross Piece
Square Washer
Longitudinal