Installation Manual

Page 5 of 8
www.generalspecialtiesmfg.com
208-265-5244
Attach aluminum angle brackets to longitudinals with smaller square U-Bolts and whiz flange nuts.
Oppose aluminum angle brackets as shown. Some mounts come with aluminum angle with punched
holes for bolting on panels, and some come with aluminum extrusions which allow for panel attachment
bolts or clips to slide in the "t-slot".
Attach aluminum rails as shown. If rail ends are marked “TOP”, align them to the same end.
General view of assembly. When fastening panels to rails, place first panels at end of rails marked
“TOP” and work down until all panels are in place with bolts finger tight. Cross measure array for square,
check to see that all spaces (approx. ¼”) between panels are equal, then tighten all bolts.