User's Manual

20-527 Owner’s Manual Draft
Page 46 of 60
Note: You can only lock out talk group IDs when the scanner is in the closed mode (see “Open and
Closed Modes” on Page XX).
2. Press TRUNK.
3. Press FUNC, ^ or v to move to the desired bank.
4. Press ^ or v to select the ID memory.
5. Press L/OUT to lock out the ID. lo changes to LO.
6. To remove the lockout from a trunking ID, manually select the ID memory, and press L/OUT. LO
changes to lo.
You can confirm the ID code while the scanner shows the text when the received signal is a voice
channel.
1. Press TEXT while the scanner is receiving the voice channel and indicating the text name. The ID
code appears as MOT:XXXXXX, etc.
2. Press TEXT again to cancel.
Delay Function in ID Indication Mode
You can set the ID delay function separate from the channel delay.
1. Press FUNC then ./DELAY while you are programming the trunked ID. Use Up/Down keys to set ID
delay. ENTER key saves. 2.0 seconds appears.
2. Press ^ or v to select None, 0.5, 1.0, 1.5, 2.0, 2.5, 3.0, 3.5, or 4.0 seconds.
3. Press ENTER.
Note: When activated, ID delay watches the control channel command for the delay time when the signal
disappears from the voice channel.
Reviewing Locked-Out Talk Group IDs
You cannot clear all lockouts from a talk group at the same time.
1. Press PGM then TRUNK.