User's Manual

20-527 Owner’s Manual Draft
Page 44 of 60
save X-XX and then changes to ID#XXXX.
The first X in ID save X-XX is the sub-bank number (0-4) in the bank. XX is the number of IDs from
(00-29) in each sub-bank.
If the ID has already been stored when you press TRUNK, ID was saved appears.
Note: When you try to store more than 150 talk group IDs in a bank, Memory Full! appears. Clear some
talk group IDs in order to store new ones (see “Clearing Talk Group IDs” on Page XX).
Follow these steps to manually store talk group IDs or to edit a stored ID.
1. Press PGM.
2. Press TRUNK.
3. To select the bank where you want to store the ID, repeatedly press FUNC then ^ or v until you reach
the desired bank.
Add illust
4. Press MODE to select MO, ED, or LT.
5. Repeatedly press TRUNK to select the sub-bank
6. Press ^ or v to select the location where you desire to store the ID number.
7. Enter the talk group ID and press ENTER. If necessary, use the decimal point for a hyphen.
Add illust
8. If you want to tag the ID, press TEXT, enter the desired text tag for the ID. Then press ENTER (see
“Text Input Chart” on Page XX).
9. To store the next ID memory in sequence, press ^ and repeat Step 4.
Add illust
10. Press SCAN to start scanning.
Notes:
• If you made a mistake in Step 4, Invalid ID value appears and the scanner beeps when you press