User's Manual

20-527 Owner’s Manual Draft
Page 42 of 60
Follow these steps to program 800 MHz band Motorola trunking
Notes:
• On the 800 MHz trunking band, you can select a base frequency (normal or offset).
• On the 900 MHz trunking band, you do not need to set the base frequency (base, offset, step).
1. Press PGM then TRUNK to enter the ID program mode.
2. Press FUNC then ^ or v to select the desired bank.
3. Press MODE and select Motorola trunking mode.
4. Press FUNC then 3. Use Up/Down keys to set 800MHz Motorola ch plan NORMAL appears.
5. Press ^ or v to select NORMAL or SPLINTER and press ENTER.
• If you are uncertain about the base frequency, use the default setting. The default setting is normal.
• If you cannot receive with the normal setting, change to OFFset. The base frequency in normal is
851.0125 MHz. The base frequency in OFFset is 851.0000 MHz.
Programming Fleet Maps
You must set the fleet map if you want to receive a Motorola Type I system. Fleet maps are included along
with other information about Motorola Type I systems at www.trunkscanner.com.
Follow these steps to program a fleet map.
1. Press PGM then TRUNK.
2. For each bank you want to program, repeatedly press FUNC. Then ^ or v to select the bank.
3. Press FUNC. Then press 8. Size Code Setting appears.
Add illus
4. Enter the size code supplied with the Type I system information, referring to the instruction that
appears on the display. If the information was not supplied, try the following common fleet maps.
Block Size Code
1 2 3 4 5 6 7 8