User's Manual

20-527 Owner’s Manual Draft
Page 40 of 60
Follow these steps to program trunked frequencies:
1. Press PGM and press (or hold down) ^ or v to select the bank.
Notes: To move through the bank selection faster, press PGM then FUNC and hold down ^ or v. To move
through the banks one at a time, repeat the sequence of PGM, FUNC then ^ or v until you reach the
desired bank.
2. Press TRUNK to enter the ID program mode.
3. Repeatedly press MODE to select MO for Motorola, ED for the EDACS (GE/Ericsson), or LT for the
LTR (EF Johnson) system to scan. This sets the talk group ID decoding method to be used for the bank.
Add illust
Note: If you select conventional mode instead of MO, ED, or LT, the scanner does not scan trunked
frequencies. Trunking mode not selected, press Mode key. appears.
Add Illust
4. Press PGM to enter the program mode.
Add illust
5. Enter the desired trunking frequency then press ENTER to store.
Add illust
6. To enter additional trunking frequencies as subsequent channels in the same bank, press PGM or ^ to
access the next open channel then enter the frequencies. (See “Storing Known Frequencies into
Channels” on Page XX).
Add illust
7. Press SCAN to start scanning.
Notes:
• If you enter a frequency that has already been entered, the scanner sounds an error tone and displays
Dupl.Freq. and the channel number that has been duplicated. If the dual entry is an error press CL and
enter the correct frequency. If the dual entry is intentional press ENTER to accept.
• You may replace any frequency by selecting the bank and channel, pressing PGM and entering the