User's Manual

20-527 Owner’s Manual Draft
Page 37 of 60
Using the Keylock
Once you program your scanner, you can protect it from accidental program changes by turning on the
key lock feature. When the keypad is locked, the only controls that operate are FUNC, KEY/LIGHT,
SQUELCH, and VOLUME.
You cannot activate the key lock while you are entering a frequency into a channel.
To turn on the key lock, press FUNC then KEY/LIGHT. Key locked. appears for about 1 second. Key
locked. appears when you press any key after locking the keypad.
To turn off the key lock, press FUNC the KEY/LIGHT. The scanner beeps three times and Key unlocked.
appears.
Changing the Display Contrast
1. Press MANUAL.
2. Press FUNC then 9. Use Up/Down keys to set contrast. appears.
3. Press ^ or v to select the contrast.
4. Press ENTER to set the display contrast.
Cloning the Programmed Data
You can transfer the programmed data to and from another PRO-97 scanner using an optional
connecting cable with 1/8-inch (3.5 mm) phone plugs on both ends (not supplied, available at your local
RadioShack store).
Note: “CLONE MODE” Incorrect Model appears if the scanner receives data from another scanner other
than a PRO-97.
Follow these steps to clone the data.
1. Turn on both scanners.
2. Connect the connecting cable to each scanner’s PC/IF jack. “CLONE MODE” UP to send, remove
cable to exit. appears.
3. Press ^. Confirm send data? 1=YES Press other key for NO. appears.