User's Manual

20-527 Owner’s Manual Draft
Page 29 of 60
You can copy a frequency into a specified channel when the scanner stops on that frequency during
search mode or manual tuning.
1. Press FUNC then PGM when you find a frequency.
Store in ChXXX ? appears on the bottom line. After about 1 second, the frequency to be copied flashes on
the indicator.
2. Press the desired bank and the channel number where you want to store the frequency. The display
indicates the bank and channel number. After about 1 second, the frequency to be copied flashes.
3. Press ENTER. All the conditions such as receive mode and delay condition are copied onto the channel.
Channel Stored! briefly appears. The scanner automatically returns to search mode.
If you try to copy a frequency which is already stored, the scanner sounds the notice tone 3 times after you
press ENTER. Dupl.Freq. ChXXX appears at the bottom line. If you want to copy the duplicate frequency
anyway, press ENTER, or if not, press CL to cancel.
Copying a Frequency into a Vacant Channel in a Specified Bank
You can copy a frequency into a vacant channel in a specified bank when the scanner stops on the
frequency during search or tune mode.
1. Press FUNC then ENTER when you find a frequency you want to copy. Bank 9 Store? appears.
2. If you want to copy the frequency into bank 9, press ENTER. It is stored in the first available vacant
channel in the bank. Or, press your desired bank number to store, then press ENTER. Channel Stored!
appears for 2 seconds. All the conditions such as receiving mode and delay condition are copied on the
channel. After about 2 seconds, the scanner automatically returns to search mode.
3. If you try to copy a frequency which is already stored, the scanner sounds the notice tone 3 times after
you press ENTER. Dupl.Freq. ChXXX appears at the third lime. If you want to copy the duplicate
frequency anyway, press ENTER, or if not, press CL to cancel.
Coping a Frequency into the Priority Channel
You can copy a frequency into the priority channel (see “Priority” on Page XX) when the scanner stops on
the frequency during Search, Scan, Manual, Tune, or WX mode.
Press FUNC then PRI when the frequency is on the display. The display flashes twice and the frequency
is copied to the priority channel.
SIGNAL STALKER