User's Manual

Note

• CLONE MODE Incorrect Model appears if the scanner receives data from another

scanner other than a PRO-96.

Follow these steps to clone the data.

1. Turn on both scanners.

2. Connect the connecting cable to each scanner’s PC/IF jack. CLONE MODE UP to

send, remove cable to exit appears in the scanner’s display.

3. Press π. Confirm send data? 1=YES Press other key for NO. appears in the

scanner’s display.

4. Press 1 to send the data to the other unit or press any other key to cancel the

operation.

5. The scanner sends the data. Do not disconnect the PC/IF cable or interrupt power to

either scanner while the transfer is taking place.

6. To exit the clone mode, remove the cable.