User's Manual

SR5 Ham

SR6 Limit search (User configurable)

Follow these steps to select preprogrammed search bands and search them for active

frequencies:

1. Repeatedly press SRCH to select your desired search bank (SR0, SR1, SR2, SR3,

SR4, SR5, or SR6).

2. In the marine and CB bands, you can directly select a channel or search through the

band. When M appears at the left most position of the second line, you can directly

select a channel (refer to “Search Band Charts” beginning on Page 54). Use the

numeric keypad to select a specific two digit channel number (for example, press 1 6

ENTER to select Channel 16, or 0 5 ENTER to select channel 5). You can also

change the channels by pressing π or θ.

There are several group banks in SR2 Police/Fire and SR4 ham bands. You can turn

on the groups by pressing the group numbers. For example, to turn off group 0, press

3. Press FUNC then SRCH while M is displayed. M changes to S and now you can

search through the band. Press FUNC then SRCH again to return to the previous

mode.

4. Rotate SQUELCH clockwise and leave it set to a point just after the rushing sound

stops. After 2 seconds (if the delay feature is on), the received frequency appears

and the scanner starts searching.

5. When the scanner finds an active frequency, it stops searching, and resumes when

the transmission ends. If delay is programmed with the search range the scanner will

pause for a reply before search resumes.