User's Manual

34
• To program Motorola 800 MHz “splinter” systems, see “Programming Motorola 800
MHz Splinter Systems” on Page 36.
• To program Motorola Type I/IIi fleet maps, see “Programming Fleet Maps” Page 36
Programming EDACS Trunking Systems
Note
• It is necessary to program all EDACS system channels into your scanner in Logical
Channel Number (LCN) order, beginning with LCN 1 in channel 01 of the channel
storage bank. Do not program EDACS system channels in channel 00 of a channel
storage bank. Refer to frequency publications or Internet sites to obtain correct LCN
frequencies for the EDACS systems you wish to monitor. If the EDACS system you
are programming skips channels in the LCN order, leave those channels blank in
your scanner.
1. Press PGM and FUNC then π or θ to select the desired channel storage bank to
program.
2. Press TRUNK to access the ID list and set the correct trunking bank type. If the bank
has never been programmed with a trunking system, the scanner will display Not
trunked Press mode.
3. Press MODE until ED (EDACS) appears in the display. This sets the channel storage
bank for EDACS operation.
4. Press PGM to return to the channel storage bank.
5. Select a channel to begin programming trunking system frequencies. Used direct
channel entry or the π or θ keys.
6. Enter the trunking frequency and press ENTER. If necessary, press MODE to change
the receiving mode to ED.
7. Repeat Steps 5 and 6 to enter the other EDACS trunking system channels for the
system you wish to monitor.