User's Manual

112
Manual Mode
Keystrokes Function Page
SCAN Activates Scan Mode 49
MAN Increments to the next channel memory 50
PGM Activates Program Mode 30
WX Activates Weather Mode 63
PRI Toggles priority 40
TUNE Enters Tune Mode 60
ATT
Toggles attenuation for selected channel, or, if global attenuation is set,
toggles global attenuation on or off
68
L/OUT Toggles lockout on the selected channel 65
MODE
Cycles through valid modes for the selected channel, clears any stored CT
or DC settings
42
SRCH Activates Search Mode 52
2, 3, MAN Jumps to channel 23 in the current bank 30
1, 2, 3, MAN Jumps to bank 1, channel 23 30
DECIMAL POINT Toggles delay on selected channel on or off 65
ENTER
When monitoring a conventional channel that is programmed for CT or DC
Search Mode, stores a detected CT or DC code with the channel memory
51
π or θ
π steps to the next channel, θ steps to the previous channel, hold down to
scroll
30
FUNC + MAN Toggles digital AGC 78
FUNC + TRUNK Enters trunked ID list for current bank 33
FUNC + PRI Stores the frequency of the selected channel into the priority channel 41
FUNC + TUNE
Stores the frequency of the selected channel frequency into the tune
memory
60
FUNC + ATT Toggles attenuator mode, normal or global 68
FUNC + 5 Toggles open or closed mode for current bank 83
FUNC + 9 Adjust display contrast, use π or θ then ENTER 71
FUNC + L/OUT Jumps to the next locked out channel 66
FUNC + π or θ
π jumps forward to the next bank, θ jumps to the previous bank, hold down
to scroll
30