User's Manual

104
RESETTING/INITIALIZING THE SCANNER
If the scanner’s display locks up or does not work properly after you connect a power
source, you might need to reset or initialize it.
IMPORTANT
If you have problems with the scanner, first try to reset it to retain all memory. If that does
not work, you can initialize the scanner.
You may be able to save the information in your scanner’s memory into your computer, a
V-Scanner folder or another scanner before trying to initialize it. See “Cloning the
Programmed Data” on Page 78 and “Working with V-Scanners” on Page 71.
Resetting the Scanner
1. Turn off the scanner, then turn it on again.
2. Insert a pointed object, such as a straightened paper clip, into the reset opening on
the side of the scanner. Then gently press and release the reset button inside the
opening.
Note
• Pressing the reset button does not clear the scanner’s working memory or the
V-Scanner folders.
Initializing the Scanner
IMPORTANT
This procedure clears all information you stored in the scanner’s working memory.
Initialize the scanner only when you are sure the scanner is not working properly.
V-Scanner memory is not affected when the scanner is initialized.
1. Turn off the scanner, then turn it on again. The scanner briefly displays the DSP boot
version, and then Welcome To Digital Trunking appears.
2. Press 0. The scanner displays
!
!