User's Manual

20-496 Owner’s Manual Draft Page 37/78
108.000 – 136.9875 12.5
Search bank: SR5 Ham band
Receive mode: FM/Digital, CT, DC or AM (depending on group)
Group Frequency (MHz) Step (kHz)
0 28.0000 – 29.7000 5
1 50.0000 – 54.0000 5
2 144.0000 – 148.0000 5
3 222.0000 – 225.0000 5
4 420.0000 – 450.0000 12.5
5 1240.0000 – 1300.0000 6.25
Search bank: SR6 Programmable limit search
Receive mode: FM/Digital, AM, CT or DC
Searching Active Frequencies in Your Desired Frequency Range
You can search a specific range of frequencies by programming SR6 with lower and upper frequency limits.
1. Press PROG then SRCH. PSR (Program Search) appears in the top line and the cursor blinks L on the
second line for the lower limit frequency.
2. Use the number keys and ./DELAY to enter the desired lower limit frequency (including the decimal
point).
3. Press ENT to set the lower limit frequency. The cursor moves to upper frequency field. If the entered
frequency is incorrect, Invalid Freq briefly appears in the scanner’s display.
4. Enter your desired upper frequency and press ENT.
5. Rotate SQ clockwise and leave it set to a point just after the rushing sound stops.
6. Press SRCH to start searching. When the scanner finds an active frequency, it stops searching.
USING ZEROMATIC
You can set Zeromatic on or off by pressing FUNC then 0. Press FUNC, and then 0 again to toggle the
Zeromatic setting. When this feature is turned on, Zeromatic ON briefly appears in the display, then z
appears at the first digit of the second line. When searching with Zeromatic on, the scanner will
automatically tune to the correct center frequency (or the step increment closest to the correct center
frequency). When searching with Zeromatic off, the scanner will unmute faster on a detected signal but the
frequency may not be exact. If the scanner stops on a signal before it reaches the correct center frequency,