User's Manual

20-496 Owner’s Manual Draft Page 23/78
. The default setting of the bank is for Motorola Type II. However, if you set Type I and wish to restore Type
II, enter 15 at Step 4.
. To confirm the input, repeat Steps 1-4 and press ENT. Each time you press ENT, you confirm the size
code. If you find an error, press CEALR and begin again at Step 1.
Block Size Code
1 2 3 4 5 6 7 8
0 S11 S4 S4 S12 S4 S3 S10 S1
1 S11 S4 S4 — S4 S10 S10 S1
2 S11 S4 S4 S4 S12 S4 S11 S2
3 S11 S4 S4 S4 — S4 S4 S2
4 S11 S4 S4 S4 S4 S12 S4 S3
5 S11 S4 S4 S4 S4 — S4 S3
6 S11 S4 S12 S4 S4 S12 S4 S4
7 S11 S4 — S4 S4 — S4 S4
Block Size Code
9 10 11 12 13 14 15 16
0 S4 S0 S4 S0 S3 S4 S4 S3
1 S4 S0 S0 S0 S3 S3 S4 S10
2 S0 S0 S0 S0 S11 S10 S4 S10
3 S0 S0 S0 S0 S4 S4 S11 S11
4 S0 S0 S0 S0 S4 S4 S11 S0
5 S0 S0 S0 S0 S0 S4 S0 S0
6 S0 S4 S0 S0 S0 S12 S12 S12
7 S0 S4 S0 S4 S0 — — —
Press ENT for each entry. If you make a mistake, press CLEAR and enter the correct size code.
Talkgroup IDs
Each channel storage bank has an associated talkgroup ID list, for a total of 10 talkgroup ID lists. Each ID
list has 5 sub-banks. Each sub-bank has 30 ID locations. You can program up to 150 talkgroup IDs in each
bank, so you can program up to 1500 talkgroup IDs in 10 banks. When the scanner stops on a
transmission in the Motorola or EDACS mode, it checks to see if the ID has been stored in the associated
ID list. In the Closed Mode, the scanner only stops on the transmission and displays its text tag if you have
stored and not locked out the ID. In the Open Mode, the scanner always stops on all transmissions except
those you specifically exclude, and displays the ID’s text tag if you have stored the ID. For a detailed
description of Open and Closed Mode operation, see “Open and Closed Mode Operation” on Page XX.
Storing Talkgroup IDs
Each talkgroup on a trunked radio system is identified by a talkgroup ID. You can store talkgroup IDs