User's Manual

20-496 Owner’s Manual Draft Page 20/78
outlined above for Motorola systems. Your scanner will automatically detect the proper control channel
type.
. Some systems rotate the control channel on a daily basis. For best results, program all known control
channel frequencies into the trunking channel storage bank.
. To program Motorola UHF trunking systems, see “Programming Motorola VHF and UHF Trunking
Systems” on Page XX.
. To program Motorola 800 MHz “splinter” systems, see “Programming Motorola 800 MHz Splinter
Systems” on Page XX.
. To program Motorola Type I/IIi fleet maps, see “Programming Fleet Maps” on Page XX.
2. Press TRUNK to access the ID list and set the correct trunking bank type. If the bank has never been
programmed with a trunking system, the scanner will display Not trunked! Press mode.
3. Press MODE until Motorola appears in the display. This sets the channel storage bank for Motorola
operation.
4. Press PROG to return to the channel storage bank.
5. Select a channel to begin programming trunking system frequencies. Use direct channel entry or the ^ or
v keys.
6. Enter the trunking frequency and press ENT. If necessary, press MODE to change the receiving mode to
MO (Motorola).
7. Repeat Steps 5 and 6 to enter the other trunking system control channel frequencies for the system you
wish to monitor.
PROGRAMMING EDACS TRUNKING SYSTEMS
1. Press PROG and FUNC, and then ^ or v to select the desired channel storage bank to program.
Note: It is necessary to program all EDACS system channels into your scanner in Logical Channel Number
(LCN) order, beginning with LCN 1 in channel 01 of the channel storage bank. Do not program EDACS
system channels in channel 00 of a channel storage bank. Refer to frequency publications or Internet
sites to obtain correct LCN frequencies for the EDACS systems you wish to monitor. If the EDACS
system you are programming skips channels in the LCN order, leave those channels blank in your scanner.
2. Press TRUNK to access the ID list and set the correct trunking bank type. If the bank has never been
programmed with a trunking system, the scanner will display Not trunked! Press mode.
3. Press MODE until EDACS appears in the display. This sets the channel storage bank for EDACS
operation.