User's Manual

20-405 User’s Guide DRAFT
4. SEndInG appears at the host scanner.
The scanner sends the data. To exit the clone mode, remove the cable.
No ConnEct appears when you connect the other model’s scanner (except PRO-405). PRO-405
scanner does not clone to the other model’s scanner.
Programming with a Personal Computer
You can also upload or download programmed data to or from a PC using a USB cable available
from your local RadioShack store or www.RadioShack.com
.
The application software is available online. Use a search engine to find “scanner programming
software.” Follow instructions in the software package to upload and download data.
Initializing the Scanner
If the scanner’s display locks up or does not work properly after you connect a power source, you
might need to initialize the scanner.
Important: This procedure clears all information you stored in the scanner’s memory. Only initialize
the scanner when you are sure the scanner is not working properly.
1. Turn off the scanner, then turn it on again. WELCOME SCAnnInG rECEIVEr appears.
2. Press 0, then press 1 while the welcome message is on the screen. InItIAL appears for about two
seconds, then YES –––Ent and No ––CLEAr appears alternately.
3. Press ENT. WAIt appears for about two seconds.
Note: Do not turn off the scanner until the initialization is complete. When the initialization is
complete, 1CH 000.0000 appears on the display.
Troubleshooting
Page 25