User's Manual

20-405 User’s Guide DRAFT
2. If you want to change banks, enter the new bank number.
3. Press ENT to store the frequency. The channel and frequency flash twice. To cancel the operation,
press TUNE/CLEAR.
Notes:
• The frequency is automatically stored in the first empty channel of the selected bank.
• If the scanner displays –dUPL–, the frequency is already stored in another channel. Press ENT if
you want to continue storing the frequency. Press TUNE/CLEAR to cancel.
• If there are no empty channels in the bank, Ch-FULL appears. You can select another bank or
clear some channels in the current bank (see “Clearing a Stored Channel” on page XX).
Scanning the Stored Channels
Press SCAN/MAN until SCAN appears to continuously scan through all channels with stored
frequencies.
If the scanner finds an active frequency, it stops and displays that channel and frequency number,
then it automatically begins scanning again when the transmission on that frequency ends.
Notes:
• Press UP or DOWN to reverse the scanning direction.
• Press •/DELAY to set the scanner to remain on the current channel for two seconds after the
transmission ends.
• To set the scanner to remain on the current channel, even after the transmission stops, press
SCAN/MAN at any time during the transmission so MAN appears and SCAN disappears (see
“Monitoring a Stored Channel” below).
• Press L/O to lock-out a channel.
Turning Channel-Storage Banks On and Off
To turn a channel-storage bank on or off, press the bank’s number key (1-0, using 0 for bank 10)
during scanning. The channel-storage banks are on when they have a bar underneath them and off
when no bar appears underneath them.
Page 16