User Manual

PSR-410 O/Manual

. In

TUNE mode, when the radio is tuned to a trunking control channel

. In TSYS analysis mode, when the radio is tuned to an active control channel in the TSYS channel list

Expanded CCDump data includes all of the data that is provided in the Basic CCDump data display, and

provides additional human-readable decoding of certain trunked control channel messages. Expanded

CCDump data is sent to the PC/IF port under the following condition:

. When the radio is monitoring a trunked control channel while in MAN or SCAN modes

Under certain circumstances the CCDump output may interfere with the cloning process. If you experience

problems with cloning, ensure that CCDump is turned off by pressing the PGM key, then the FUNC key,

then the GLOB softkey, then scrolling to the CCDump menu item. If necessary, turn CCDump off by

pressing the left or right arrow key, then press the Save softkey to save the setting.

The following describes the CCDump message format for the supported modes:

<Msg Type>:T<xxxx>:<CC data>[:<Expanded CCDump description>]

<Msg Type>= always 3 ASCII chars:

WXS (WX SAME)

WXT (WX 1050Hz tone)

M36, LTR, EDW, EDN

<xxxx> = the hexadecimal representation of the TSYS's File System ID (for WXS and WXT, this is the

current Wx Chan 0-6, if in TUNE mode, “AAAA”)

<CC data> = the "osw" from the CC. The format necessarily depends on the system type:

M36: <cmd> <dir> <id>

<cmd> = 3-digit (10-bit) hex "command" value

<dir> = direction bit

<id> = 4-digit (16-bit) hex "id" value

LTR: <RR>: <A>-<GG>-<HH>-<III>-<FF>

<RR> = repeater on which the msg was received

<A> = area

<GG> = Goto/In-Use repeater #

<HH> = Home Repeater #

Page