User Manual

PSR-410 O/Manual
modulation,
Atten On or Off When on, applies 20 dB of
attenuation to all hits received on the
LMIT search. Useful in areas where
interference from nearby strong
signals is present.
Delay On or Off Controls whether a Delay is used to
wait for reply traffic after a
transmission is received during the
LMIT search.
Delay Time 1-200 Sets the amount of time (in 100
millisecond intervals) for the wait for
reply delay if Delay is On, e.g., 20=2
seconds.
Zeromatic On or Off When on, enhances the scanner's
ability to lock on to the actual center
frequency of a search hit instead of
an adjacent frequency.
Search Dir Up or Down Sets search direction used when
LMIT object is active.
Hit Count Numeric value Increments each time a transmission
is received on the SWPR object.
Global “Hit Counts” must be set to
ON. Press the Dflt softkey to reset to
0.
SRVC Menu Reference
The SRVC menu is used when creating new Service Search objects, or editing existing Service Search
objects. All menus are shown in the scanner's display as a three line window that can be scrolled up or
down to access the various different parameters. The active parameter is always the middle parameter and
is indicated by a flashing “:”. The entire SRVC menu is shown below:
SRVC Parameter Options Description
Scan Lists On or Off for Scan Lists
1-22
Sets membership in Scan Lists. Use
<> keys to scroll through Scan Lists.
Use SEL key to toggle Scan List
membership. A “*” next to the Scan
Page
79