User Manual

PSR-410 O/Manual
Use None to
ignore subaudible squelch.
Use CTCSS for tone coded squelch, or
DCS for digital coded squelch. Used in
conjunction with Squelch Code
parameter below.
Squelch
Code/CTCSS
Hz/DCS Code
Search, CTCSS tone,
DCS Code, n/a
Sets CTCSS tone, or DCS code
depending on Sq Mode setting. Use
Search to detect tone or code value for
selected squelch type.
L/Out On or Off Permanent lockout for the CONV
channel. Also accessed by pressing
FUNC L/OUT while the scanner is
stopped on the CONV object.
Priority On or Off Turns Priority Mode on or off for the
CONV object.
LED Mode Solid or Flash Controls whether the ALERT LED
flashes or remains on solid when the
ALERT LED is used.
LED Color 0-7 Sets LED color to 0-7 as defined in the
GLOB menu. By default, 0=LED Off,
1=Red, 2=Yellow, 3=Green, 4=Cyan,
5=Blue, 6=Magenta, 7=White.
Latch LED On or Off Normally the ALERT LED is active only
while the object is receiving a
transmission. When Latch is on, the
ALERT LED will remain lit after the
transmission is complete, unless
overridden by a subsequent object that is
also using the ALERT LED.
Backlight On, Off or Flash Controls whether the backlight should be
on, off or flashing while the object is
active. “Off” setting is ignored by the
PSR-410.
Alarm None, Chirp, Hi-Lo,
Alert, Ring, 2-Chirp,
Fast Hi-Lo, DTMF#
Sets the Audible Alarm for the CONV
object. When an Audible Alarm is
selected, the selected alarm will play at
the beginning of each transmission on
the CONV object, or anytime the scanner
stops for activity on the CONV object
Page
71