User Manual

PSR-410 O/Manual
key
s to scroll to R, G or B LED settings.
Use numeric keys to activate preset
intensity levels for each LED, or use ^v
keys to fine scroll intensity.
Qtxt1-0 Text value Sets QTXT (QuickText) 0-9 text. Use “$”
to indicate end of text.
Key Repeat On or Off Toggles key repeat mode when a key is
held down
LCD BlinkOff 1-250 x 10 mS For alternating text displays, sets the
display time for the secondary display
element.
LCD BlinkOn 1-250 x 10 mS For alternating text displays, sets the
display time for the primary display
element.
LED BlinkOff 1-250 x 10 mS When the ALERT LED setting for an
object is set to Flash, this is the amount
of time the LED stays turned off.
LED BlinkOn 1-250 x 10 mS When the ALERT LED setting for an
object is set to Flash, this is the amount
of time the LED stays turned on.
Pri Channels 0-250 Number of priority CONV channels to
check during a priority scan sampling.
“0” samples all CONV priority channels.
Pri Interval 2-100 x 100 mS Conventional frequency priority sample
interval.
TGRP Pri Int On or Off Toggles priority interrupt scanning during
trunked calls
QuickPriRtn On or Off When on, does not wait for verification of
correct CTCSS, or DCS when returning
to an active CONV channel after priority
sampling
Search Delay 1-100 x 100 mS Sets wait for reply delay for all search
modes
TLO=FUNC L/O On or Off Controls the operation of the L/OUT key.
When Off, pressing L/OUT performs a
Temporary Lockout of the selected
object. When On, pressing L/OUT
performs a Permanent Lockout of the
selected object.
Page
69