User Manual

PSR-410 O/Manual
“tweak” these settings to
your liking. The default settings will work fine for most users, but most users will
want to use the GLOB menu to personalize the radio to suit their individual tastes. The active parameter is
always the middle parameter and is indicated by a flashing “:”. The entire GLOB menu is shown below.
Note that some GLOB parameter changes do not take effect until the GLOB menu is saved.
HINT: You can restore all GLOB settings to their defaults without affecting your programmed objects. Power
cycle the radio, then press 0, then 2 during the welcome message display. Press ENT to confirm the GLOB
parameter reset.
GLOB Parameter Options Description
CONTRAST 1-7 Sets LCD contrast. Use <> keys on
5-way pushbutton pad.
Owner SEL Enters sub menu to set Welcome
Message text display.
Font Normal, Bold Sets displayed font. Use <> keys on
5-way pushbutton pad.
Clone Send SEL Press SEL to send data using clone
mode
Alert Mode Both, Tone, Light, Off Controls the ALERT LED and Audible
Alarm behavior. Both allows the LED
and Tone. Tone allows the audible
alarm only. Light allows the LED only.
Off deactivates the ALERT LED and
Audible Alarm feature.
Sound Mode On or Stlth Controls all radio beeps.
Key Beeps On or Off Controls key beeps.
Light Mode Norml, Stlth Controls the backlight operation. Norml
(Normal) causes the backlight to
remain on all the time. Stlth (Steath)
disables the backlight.
Light Level Brit, Dim, Off Controls backlight intensity. When Dim
LED is set to Yes, also controls Alert
LED intensity. Accessed from front
panel using DIM key.
Dim LED Yes or No When Yes, DIM key and Light Level
GLOB menu parameter also control
intensity of Alert LED.
Atten Mode Global or Normal The attenuator reduces the amount of
signal at the receiver input. This helps
Page
67