User Manual

PSR-410 O/Manual

urn SQUELCH control clockwise until scanning

resumes

Initializing Global Parameters to Factory Defaults

If your scanner does not appear to be functioning properly, you can reset the global radio parameters to

their factory state without losing any of your programmed data. Any custom changes you have made to the

radio's global parameters will be lost.

NOTE: This procedure preserves the information you stored in the scanner's working memory, while

resetting all global radio parameters to factory defaults.

1. Turn off the scanner, then turn it on again. The scanner displays Welcome/Owner screen.

2. Press 0 while the scanner is displaying the Welcome/Owner screen. The scanner displays

System Tests:

Select a Test...

Exits if no key

is pressed

3. Press 2. The scanner displays

Init GLOB data

To factory state

ENTER if APPROVE

CLEAR to EXIT

4. Press ENT. The scanner displays

GLOB EEPROM area

Initialized to

defaults.

Press any key.

5. Press any key on the keypad to proceed. The scanner will reboot with file system and global parameters

reset to factory defaults.

Initializing the Scanner to Factory Defaults

Page