User Manual

PSR-410 O/Manual
Mobile opera
tion
By attaching the mounting bracket such that it is located on top of the radio, it is possible to mount the radio
underneath your vehicle’s dashboard, or in any other mounting location where the radio will be suspended
from above. You may also use the mounting bracket such that it is located underneath of the radio, which
makes it possible to mount the radio on top of any flat surface in your vehicle.
Your PSR-410 is also designed to fit into a DIN-E compatible sleeve, which makes it easy to mount the
radio in an existing radio or CD player dashboard opening. An optional DIN-E installation kit can be
purchased form GRE at:
http://www.greamerica.com
Note: In certain cases, installation of mobile communications electronics in modern automobiles requires
specialized tools, training, and experience. If in doubt, seek assistance from a local car audio electronics
installation shop, or a local two-way radio dealer.
Select a mounting location that does not interfere with visibility while driving. Use caution not to select a
location that may interfere with the deployment of your vehicle’s air bags. It is extremely important not to
mount this or any other equipment in locations where deployment of the air bags may cause the equipment
to be propelled towards the vehicle’s passengers. If necessary, seek advice from your automotive dealer or
service shop.
Use the mounting bracket as a template to mark the locations for the two mounting screws.
At the marked locations, drill holes that are slightly smaller than the screws. Use caution not to damage
wiring or components that are located behind the mounting surface.
Using the provided screws and lock washers, attach the mounting bracket to your vehicle.
Attach the two self-adhesive rubber washers to the inside of the mounting bracket sides, over the holes that
are used when attaching the bracket to the scanner’s side holes. The rubber washers help protect the
scanner’s case from scratches.
Slide the scanner into the mounting bracket assembly, and use the two provided knurled knobs to secure
the scanner within the mounting bracket.
Connect the supplied DC power cable to a power source in your vehicles as follows:
Page
13