User's Manual

CCDump data is sent to the PC/IF port under the following condition:
. When the radio is monitoring a trunked control channel while in MAN or SCAN modes
Under certain circumstances the CCDump output may interfere with the cloning process. If you experience
problems with cloning, ensure that CCDump is turned off by pressing the PGM key, then the FUNC key,
then the GLOB softkey, then scrolling to the CCDump menu item. If necessary, turn CCDump off by
pressing the left or right arrow key, then press the Save softkey to save the setting.
The following describes the CCDump message format for the supported modes:
<Msg Type>:T<xxxx>:<CC data>[:<Expanded CCDump description>]
<Msg Type>= always 3 ASCII chars:
WXS (WX SAME)
WXT (WX 1050Hz tone)
M36, LTR, EDW, EDN
<xxxx> = the hexadecimal representation of the TSYS's File System ID (for WXS and WXT,
this is the current Wx Chan 0-6, if in TUNE mode, “AAAA”)
<CC data> = the "osw" from the CC. The format necessarily
depends on the system type:
M36: <cmd> <dir> <id>
<cmd> = 3-digit (10-bit) hex "command" value
<dir> = direction bit
<id> = 4-digit (16-bit) hex "id" value
LTR: <RR>: <A>-<GG>-<HH>-<III>-<FF>
<RR> = repeater on which the msg was received
<A> = area
<GG> = Goto/In-Use repeater #
<HH> = Home Repeater #
<III> = Group ID
<FF> = Free Repeater #
EDW: <W>: <ccc> <ppppppp>
<W> = which of the two blocks (0 or 1) in the msg pair this is <ccc> =