User's Manual

Atten On or Off When on, applies 20 dB of
attenuation to all hits received on the
SWPR search. Useful in areas where
interference from nearby strong
signals is present.
Delay On or Off Controls whether a Delay is used to
wait for reply traffic after a
transmission on the SWPR search.
Delay Time 1-200 Sets the amount of time (in 100
millisecond intervals) for the wait for
reply delay if Delay is On, e.g., 20=2
seconds.
Zeromatic On or Off When on, enhances the scanner's
ability to lock on to the actual center
frequency of a search hit instead of
an adjacent frequency.
Special On or Off SWPR works by quickly sweeping
the RF spectrum in 1 MHz
increments to find nearby strong
signals. If the 1 MHz sweep indicates
that activity is present in the 1 MHz
range, SWPR sweeps that range to
find the source.
Search Dir Up or Down Sets search direction used when
SWPR object is active.
Hit Count Numeric value Increments each time a transmission
is received on the SWPR object.
Global “Hit Counts” must be set to
ON. Press the Dflt softkey to reset to
0.
Appendix A - Remote Control Protocol
NOTE: GRE provides Memory File Format, CCDump Protocol, PC/IF Clone Protocol and Remote Control
Protocol Specifications (the "Specifications") AS IS for the convenience of scanning hobbyists and
programmers who wish to develop software applications for use with the PSR-310. Use of the
Specifications shall be AT YOUR OWN RISK. GRE does not provide Memory File Format, CCDump