User's Manual

search. In most cases Auto will work
fine. Use AM to override and force
AM modulation, FM to force FM
modulation, NFM to force narrow FM
modulation.
Atten On or Off When on, applies 20 dB of
attenuation to all hits received on the
SRVC search. Useful in areas where
interference from nearby strong
signals is present.
Delay On or Off Controls whether a Delay is used to
wait for reply traffic after a
transmission on the SRVC search.
Delay Time 1-200 Sets the amount of time (in 100
millisecond intervals) for the wait for
reply delay if Delay is On, e.g., 20=2
seconds.
Zeromatic On or Off When on, enhances the scanner's
ability to lock on to the actual center
frequency of a search hit instead of
an adjacent frequency.
Search Dir Up or Down Sets search direction used when
SRVC object is active.
Hit Count Numeric value Increments each time a transmission
is received on the SWPR object.
Global “Hit Counts” must be set to
ON. Press the Dflt softkey to reset to
0.
SWPR Menu Reference
The SWPR menu is used when creating new Spectrum Sweeper objects, or editing existing Spectrum
Sweeper objects. All menus are shown in the scanner's display as a three line window that can be scrolled
up or down to access the various different parameters. The active parameter is always the middle
parameter and is indicated by a flashing “:”. The entire SWPR menu is shown below:
SWPR Parameter Options Description
Scan Lists On or Off for Scan Lists Sets membership in Scan Lists. Use