User's Manual

ALERT LED is used.
LED Color 0-7 Sets LED color to 0-7 as defined in
the GLOB menu. By default, 0=LED
Off, 1=Red, 2=Yellow, 3=Green,
4=Cyan, 5=Blue, 6=Magenta,
7=White.
Latch LED On or Off Normally the ALERT LED is active
only while the object is receiving a
transmission. When Latch is on, the
ALERT LED will remain lit after the
transmission is complete, unless
overridden by a subsequent object
that is also using the ALERT LED.
Backlight On, Off or Flash Controls whether the backlight
should be on, off or flashing while the
object is active.
Alarm None, Chirp, Hi-Lo, Alert,
Ring, 2-Chirp, Fast Hi-Lo,
DTMF#
Sets the Audible Alarm for the LMIT
object. When an Audible Alarm is
selected, the selected alarm will play
anytime the scanner stops for activity
on the LMIT object while scanning.
Fav Yes or No When Yes, the LMIT object is a
member of the Favorites Scan List.
EXPERT BELOW
Modulation AM, FM, NFM, Auto Modulation setting for the LMIT
search. In most cases Auto will work
fine. Use AM to override and force
AM modulation, FM to force FM
modulation, NFM to force narrow FM
modulation.
Atten On or Off When on, applies 20 dB of
attenuation to all hits received on the
LMIT search. Useful in areas where
interference from nearby strong
signals is present.
Delay On or Off Controls whether a Delay is used to
wait for reply traffic after a
transmission is received during the
LMIT search.