User's Manual

4. Press ENT. The scanner displays
GLOB EEPROM area
Initialized to
defaults.
Press any key.
5. Press any key on the keypad to proceed. The scanner will reboot with file system and global parameters
reset to factory defaults.
Initializing the Scanner to Factory Defaults
If initializing the global parameters to factory defaults does not resolve your problem, you may wish to
initialize the entire scanner to factory defaults. This operation will result in the clearing of your programmed
data and the loss of any custom changes you have made to the radio's global parameters. Use this option
as a last result, and, if possible, save your working memory to a V-Scanner folder prior to performing this
operation.
NOTE: This procedure clears all information you stored in the scanner's working memory, AND resets the
global parameters to factory defautls. Initialize the scanner only when you are sure the scanner is not
working properly. V-Scanner memory is not affected when the scanner is initialized.
1. Turn off the scanner, then turn it on again. The scanner briefly displays the Welcome/Owner screen.
2. Press 0 while the scanner is displaying the Welcome/Owner screen. The scanner displays
System Tests:
Select a Test...
Exits if no key
is pressed
3. Press 1. The scanner displays
Factory Init
Erase Memory
ENTER if APPROVE
CLEAR to EXIT
4. Press ENT. The scanner displays