User's Manual

Follow steps below to initialize the scanner
Scanner will not scan when SCAN key is pressed
Possible “birdie” frequency programmed
Tighten squelch, apply attenuator or lock out the
“birdie” frequency
The scanner may need to be reset or initialized
Follow steps to reset/reinitialize the scanner
following this table
No channels programmed, or only one channel programmed, or all channels locked out
Ensure that the scanner has more than one
channel programmed and enabled for scanning
SQUELCH control is not adjusted properly
Turn SQUELCH control clockwise until scanning
resumes
Initializing Global Parameters to Factory Defaults
If your scanner does not appear to be functioning properly, you can reset the global radio parameters to
their factory state without losing any of your programmed data. Any custom changes you have made to the
radio's global parameters will be lost.
NOTE: This procedure preserves the information you stored in the scanner's working memory, while
resetting all global radio parameters to factory defaults. V-Scanner memory is not affected by this
operation.
1. Turn off the scanner, then turn it on again. The scanner displays Welcome/Owner screen.
2. Press 0 while the scanner is displaying the Welcome/Owner screen. The scanner displays
System Tests:
Select a Test...
Exits if no key
is pressed
3. Press 2. The scanner displays
Init GLOB data
To factory state
ENTER if APPROVE
CLEAR to EXIT