User's Manual

illust
By default, TUNE mode is paused when first activated. Press PSE to begin searching from the current
frequency.
Press the ^ or v keys on the 5-way pushbutton pad to change the search direction.
Press the FrL/O softkey to add a found frequency to the lockout list.
Press the MODE softkey to change the receive mode (AM, FM, NFM) from the default for the current
frequency range (au).
Press STOR to create a new CONV object using the found frequency.
Use the keypad to enter a new frequency, and press ENT to make that the TUNE frequency.
Using FUNC TUNE from any other mode will load the last active frequency from the other mode into TUNE.
For example, pressing FUNC TUNE while parked on a trunked radio TGRP will load the control channel
frequency into the TUNE mode if the control channel frequency is the last frequency that the scanner
checked while scanning.
Dedicated TUNE mode will always check for the presence of encoded squelch modulation each time it
finds an active frequency. If a valid encoded squelch code is found, it will be shown on the display, and
stored automatically when you press STOR to create a new CONV object.
Dedicated TUNE mode also displays information about trunking control channels and trunked voice
channels it finds while tuning through the RF spectrum. The following information is displayed for the
various trunking modes:
Trunked Mode Analysis Display
Motorola 3600 baud control channel qq% SID:ssss Stt
where qq=decoding quality of the control
channel data, SID=System ID, and S=Site
Number
EDACS control channel qq% S:ss h/H s/S a/A
where qq=decoding quality of the control
channel data, S=Site ID, h/H=not home
site/is home site, s/S=not SCAT site/is SCAT