User's Manual

moving and are within range of more than one tower site, as it will allow you to monitor traffic from any
tower that you are within range of.
To activate Multi-site mode on a Motorola networked system, follow these steps:
Press PGM, then navigate to a talkgroup on the networked multi-site system using the <>^v keys.
Press the EDIT softkey, then press the CURR softkey.
Scroll down to the TSYS item and press the SEL key to edit the TSYS parameters.
Scroll to Multi-Site. Use the <> keys to select Off, Stat or Roam. When set to Off, the scanner will find the
first usable control channel in the control channel list and use it until it is no longer usable. When set to
Stat(ionary), the scanner will track the system using any control channel in the list that is usable. When set
to Roam, the scanner will attempt to locate and use the best possible control channel and ignore others,
until the control channel is no longer usable, then it will locate a new “best control channel” to use. When
Multi-Site=ROAM, the scanner will always attempt to lock on to control channels where the decoding
quality is greater than the Threshold Hi setting, and will search for new control channels when the decoding
quality of a control channel drops below Threshold Lo setting, and, if no new control channels are available
that meet the Threshold Hi criteria, the scanner will seek the best control channel to use, and continue
checking periodically for a new control channel that meets the Threshold Hi criteria. When Multi-Site=STAT,
the scanner will track the system using every usable control channel in the control channel list.
Press the SAVE softkey to save your changes to the TSYS parameters, then press the SAVE softkey again
to use the scanner.
You should experiment with the different Multi-site modes and the threshold settings to find a combination
that works best for your location. Keep in mind that the threshold settings are only available when Multi-Site
Roam is selected.
Multi-site functionality is not available in EDACS or LTR trunking.
NOTE: It may be necessary to change the values used for Threshold Hi and Threshold Low in the TSYS
object to optimize Multi-site Roam performance.
LTR Home Repeater AutoMove
LTR Home Repeater AutoMove takes the guesswork out of programming LTR trunking systems when the
home repeater order is not known.