User's Manual

PSR-200U Owner’s Manual Draft
The scanner is on but does not scan. What’s wrong?
• The squelch might not be adjusted correctly. Turn SQ clockwise. There might only be one
channel or no channels stored in the scanner. Store frequencies into more than one
channel.
While scanning, the scanner locks on frequencies that have an unclear transmission. What’s
wrong?
• Some frequencies programmed into the scanner might be the same as “birdie” frequencies.
Avoid programming “Birdie Frequencies” or only listen to them manually.
CARE
Keep the scanner dry; if it gets wet, wipe it dry immediately. Use and store the scanner only
in normal temperature environments. Handle the scanner carefully; do not drop it. Keep the
scanner away from dust and dirt, and wipe it with a damp cloth occasionally to keep it
looking new.
IN CASE OF FAULT
Where a fault arises, contact your supplier. However, before you do so check that the fault
was not caused by an operational error. Carefully reread the relevant section in the
instructions.
SPECIFICATIONS
Frequency Coverage (MHz):
29–54.0000 (in 5 kHz steps/FM)
87.3–107.9 (in 100 kHz steps/WFM)
108–136.99166 (in 8.33 kHz steps/AM)
137–143.9875 (in 12.5 kHz steps/FM)
144–148.0000 (in 5 kHz steps/FM)
148.0125–150.7875 (in 12.5 kHz steps/FM)
150.8000–161.9950 (in 5 kHz steps/FM)
162.0000–174.0000 (in 12.5 kHz steps/FM)
Page 34