User's Manual

PSR-200U Owner’s Manual Draft
3. Press and hold ENT then PRI. P ChAnnEL is displayed momentarily. After P ChAnnEL
appears, PCH flashes and 000.0000 or the previously-stored frequency appears.
4. Press ENT to store the priority channel and display blinks two times. Press CLEAR to
cancel.
To turn on the priority feature, press PRI during scanning or searching. PRI appears. The
scanner checks the priority channel every 2 seconds and stays on the channel if there is
activity. PCH and the frequency appear whenever the scanner is set to the priority channel.
To turn off the priority feature, press PRI. PRI disappears.
Note: If you program a weather frequency into the priority channel and the scanner detects a
WX alert tone on that frequency (see “SAME Standby mode” on Page XX), the scanner
sounds the alert tone and ALErt flashes. Press any key to turn off the alarm.
TURNING THE KEY TONE ON AND OFF
The scanner is preset to sound a tone each time you press one of its keys. You can turn the
key tone off or on.
1. If the scanner is on, slide POWER to off.
2. Slide POWER to turn on the scanner. Welcome message appears..
3. While Welcome message appears, press 1 to turn on the key tone or 2 to turn it off.
Cloning the Programmed Data
You can transfer the programmed data to and from a PSR-200U scanner using an optional
connecting cable with 3.5mm stereo phone plugs on both ends (not supplied).
1. Turn on both scanner.
2. Connect the connecting cable to each scanner’s PC/IF jack. CLOnE and UP to SEnd
appears.
Page 31