User's Manual

PSR-200U Owner’s Manual Draft
Notes:
• You cannot turn off all banks. There must be at least one active bank.
• You can manually select any channel in a bank, even if the bank is turned off.
• When you turn on a bank during scanning, the scanner moves to the selected bank and
scans it.
If no transmission is found, the scanner continues scanning to scan through all selected
banks.
MONITORING A STORED CHANNEL
You can continuously monitor a specific channel without scanning. This is useful if you hear
an emergency transmission on a channel and do not want to miss any details — even
though there might be periods of silence — or if you simply want to monitor that channel.
Follow these steps to manually select a channel.
1. Press SCAN (Orange) to enter SCAN mode. If error tone beeps, proceed to step 2.
2. Pressing SCAN/MAN until MAN appears.
3. Enter the channel number (1–200).
4. Press SCAN/MAN again.
CLEARING A STORED CHANNEL
If you no longer want a frequency stored in a channel (and you do not want to replace that
frequency with a different one), follow these steps to clear the stored frequency.
1. Pressing SCAN/MAN to stop scanning while SCAN mode.
2. To select the desired channel number, use the number keys to enter that channel number
(1–200).
Page 21