User's Manual

PSR-200U Owner’s Manual Draft
channel. See above Note on this page.
SCANNING THE STORED CHANNELS
To set the scanner to continuously scan through all channels with stored frequencies as
follows:
1. Press SCAN (Orange). If error tone beeps, proceed to step 2.
2. Simply pressing SCAN/MAN until SCAN and ^ appear, then the scanner begins to rapidly
scan until it finds an active frequency.
If the scanner finds an active frequency, it stops and displays that channel and frequency
number, then it automatically begins scanning again when the transmission on that
frequency ends.
Notes:
• To reverse the scanning direction, press ^ or v.
• To set the scanner to remain on the current channel for 2 seconds after the transmission
ends, see “Delay” on Page XX.
• To set the scanner to remain on the current channel, even after the transmission stops,
press SCAN/MAN at any time during the transmission so MAN appears and SCAN
disappears (see “Monitoring a Stored Channel”).
• To lock out channels so the scanner does not stop for a transmission on those channels,
see “Locking Out Channels or Frequencies” on Page XX.
TURNING CHANNEL-STORAGE BANKS OFF AND ON
Channel-storage banks (1–10) are on when they have a bar underneath them and off when
no bar appears underneath them. To turn off a channel-storage bank, press the bank’s
number key during scanning. The bar under the bank’s number disappears.
Note: The scanner does not scan any of the channels within the banks you have turned off.
To turn on a channel-storage bank (1–10) during scanning, press the bank’s number key. A
bar appears under the bank’s number.
Page 20