User's Manual

PSR-200U Owner’s Manual Draft
Copying a Frequency into a Vacant Channel in a Specified Bank
1. To store the displayed frequency in the desired bank’s lowest vacant channel, press
FUNC then press ENT when you find a frequency. The bank number and StorE appears.
2. If you desired to store the other bank, press number key.
3. Press ENT to store the frequency. The channel and frequency flash twice. If you want to
cancel the operation, press CLEAR/PSE instead of ENT.
Note: If you entered a frequency that is already stored in another channel, -dUPL-
(duplicate) and the lowest numbered channel containing the duplicate frequency flash for
about 3 seconds. If you want to store the frequency anyway, press ENT again. You can then
delete the frequency later. See “Clearing a Stored Channel” on Page XX.
If there is no empty channel in the bank, Ch-FULL appears after you press ENT. To store
more frequencies, you must clear some channels or you may program the other bank. See
“Clearing a Stored Channel” on Page XX. To continue searching after Ch-FULL appears,
press CLEAR/PSE.
Copying a Frequency into a Specified Channel
1. To store the displayed frequency in the desired channel memory, press FUNC then press
PGM when you find a frequency. The ChAnnEL appears about a second, then the channel
number flashes and frequency (or 000.0000) appears.
2. To change the target channel, enter the channel number.
3. Press ENT. Channel number flashes and previous frequency (or 000.0000 if it is vacant
channel) appears.
If you re-enter the channel number press channel number then press ENT.
4. Press ENT again. The channel and frequency flash twice. If you want to cancel the
operation, press CLEAR/PSE instead of ENT.
Note: If the scanner displays -dUPL-, the entered frequency is already stored in another
Page 19