User's Manual

PSR-200U Owner’s Manual Draft
The scanner displays FD/PD or AIR or HAM. After about 2 seconds, the scanner starts
search.
Notes:
• To reverse the search direction at any time, press ^ or v.
• To pause the search while receiving a signal, press PSE. To resume searching, press PSE
again.
• If necessary, you can select search groups using the number keys.
• Pressing SRCH to advance the search bands.
2. To search for another active frequency in the selected band, press ^ or v. To select a
different band and search for another active frequency, repeat Steps 1.
Using Tune
During a tune, the scanner tunes up or down, starting from a frequency you specify. Follow
these steps to use tune.
Note: You can use the scanner’s delay feature while using tune.
1. Press TUNE. PSE and start frequency appears.
(If your scanner enters into FM RADIO mode, the scanner tunes FM radio band. If your
scanner enters into SCAN or SEARCH mode, the scanner tunes all receiving frequency
band without FM radio band.)
2. If desired, you can change the start frequency. To change the start frequency, enter
frequency with numeral keys, then press ENT.
3. Press PSE/CLEAR to start tune. -t- appears on the display.
4. To change the tuning direction, press ^ or v. The scanner displays ^ or v and start tune.
Note: To pause the tune, press PSE. To resume tune, press PSE again.
5. To tune for another active frequency, press ^ or v.
Page 18