User's Manual

New Race Scanner Owner’s Manual Draft

PWR (Power) Jack

Understanding the Display

Add illustration

Setup

Powering Scanner

Installing Batteries

1. Power off the scanner.

2. Remove the battery compartment cover.

3. Set the Battery Type Selector switch to ALK for non-rechargeable alkaline batteries or

Ni-MH for rechargeable Ni-MH batteries.

4. Insert three AA batteries, matching the polarity symbols (+ and -) marked inside.

5. Replace the battery compartment cover.

! WARNING: Never install alkaline batteries with the Battery Type Selector switch set to

Ni-MH. Alkaline batteries can get hot or explode if you try to recharge them.

Battery Notes:

. A low battery warning sounds every 30 seconds (default setting) when the batteries are

nearly depleted.

. Dispose of batteries promptly and properly. Do not burn or bury them.

Page