User's Manual

New Race Scanner Owner’s Manual Draft
and press EDIT.
Note: ERROR!! Erasing DATA!! appears if the scanner cable removes the PC/IF jack. To
cancel the error, press CLR or EDIT.
Then the target scanner initializes the data. Retry the cloning the data.
Using Keylock
Once you use the scanner, you can protect it from accidental function changes by turning
on the keylock feature. When the keypad is locked, this only control that operate are FUNC
and EDIT/KEYLOCK.
To turn on/off the keylock, press FUNC then press EDIT/KEYLOCK.
CARE
Keep the scanner dry; if it gets wet, wipe it dry immediately. Use and store the scanner only
in normal temperature environments. handle the scanner carefully; do not drop it. Keep the
scanner away from dust and dirt, and wipe it with a damp close occasionally to keep it
looking new.
FAQ’s
The scanner is not working at all. What’s wrong?
. The AC or DC adapter might not be connected. Be sure the adapter’s barrel plug is fully
inserted into the PWR jack. The center tip on the adapter’s barrel plug must be set to
positive.
. The batteries might be dead or need to be recharged. Recharge the rechargeable
batteries or replace the alkaline batteries.
The scanner is on but does not scan. What’s wrong?
. The squelch might not be adjusted correctly. Set the squelch setting with EDIT menu.
The keypad does not work. What’s wrong?
Page
16