User's Manual

20-444 User’s Guide Draft

the erro

r, press CLR or EDIT.

Then the target scanner initializes the data. Retry the cloning the data.

Using Keylock

Once you use the scanner, you can protect it from accidental function changes by turning on the

keylock feature. When the keypad is locked, this only control that operate are FUNC and

EDIT/KEYLOCK.

To turn on/off the keylock, press FUNC then press EDIT/KEYLOCK.

CARE

Keep the scanner dry; if it gets wet, wipe it dry immediately. Use and store the scanner only in

normal temperature environments. Handle the scanner carefully; do not drop it. Keep the

scanner away from dust and dirt, and wipe it with a damp close occasionally to keep it looking

new.

FAQ’s

The scanner is not working at all. What’s wrong?

• The AC or DC adapter might not be connected. Be sure the adapter’s barrel plug is fully

inserted into the PWR jack. The center tip on the adapter’s barrel plug must be set to positive.

• The batteries might be dead or need to be recharged. Recharge the rechargeable batteries or

replace the alkaline batteries.

The scanner is on but does not scan. What’s wrong?

• The squelch might not be adjusted correctly. Set the squelch setting with EDIT menu.

The keypad does not work. What’s wrong?

• Key lock is turned on. Turn off keylock.

Page