User's Manual

and Off Time are speciﬁed in 10 millisecond increments, e.g., an

On Time of 50 means the light will come on for 500 milliseconds

(or one half second) for each Flash Pattern step where the light

is set to come on.

There are many different possible Flash Patterns possible with

this feature. Here are just a few that you can use to get started:

Flash Pattern: 55555555, On Time: 50, Off Time: 50

These are the default values for Flash Pattern, On Time and Off

Time. When the object is active, the LED backlight will ﬂash on

and off at a rate of one ﬂash per second, with each ﬂash lasting

half a second.

Flash Pattern: 88888888, On Time: 50, Off Time: 50

This combination causes the LED backlight to come on for a half

second every two seconds.

Flash Pattern: A8A8A8A8, On Time: 1, Off Time: 5

This combination creates an interesting “strobe light” effect

similar to the emergency lights on a public safety vehicle.

Many more combinations are possible - just experiment to ﬁnd

the ones that work for you.

To set the Flash Pattern, use the  and  keys to scroll to

Flash Pattern, then press the  key to set the pattern value.

Follow the on-screen instructions to set the value of the ﬂash

pattern, using Figure 6 above as your guide.

To set On Time and Off Time, use the  and  keys to scroll

to On Time or Off Time, then press the  key to set the value.

Follow the on-screen instructions to set the value for On Time

and Off Time.

Delete Object

Selecting Delete Object removes the object from the EZ Scan-

SDʼs working memory conﬁguration. The Library data is never

altered in any way, so if necessary, the object can be imported to

the EZ Scan-SDʼs Playlists again.

To delete the current object, use the  and  keys to scroll to

Delete Object, then press the  key to proceed with the deletion.

Follow the on-screen instructions to conﬁrm Delete Object.

GENERAL RESEARCH OF ELECTRONICS, INC. PROPRIETARY AND CONFIDENTIAL INFORMATION

EZ Scan-SD Preliminary User Manual" Page 44