User Manual

GENERAL PUMP
A member of the Interpump Group
KT16A/18A/20A/22A SERIES
Page 19
Ref 300942 Rev.A
03-14
4. REPLACING THE CON-ROD FOOT BUSHING
During maintenance, if it becomes necessary to replace the con-rod foot bushing, proceed as follows:
When removing the worn bushing, take great care not to damage or scratch the seat on
the con-rod.
Perform cold press fitting of the new bushing. During the operation, ensure that:
• the lubrication hole coincides with the corresponding hole on the con rod;
• the cutting junction is directed as shown in fig. 35.
Then perform mechanical processing. The dimensions and tolerances shown in fig. 35 MUST
be respected.