Spec Sheet

ASSEMBLY / OPERATING INSTRUCTIONS
GENERAL PUMP • 1174 Northland Drive • Mendota Heights, MN 55120
Phone: [phone] • Fax: [phone] • email: [e-mail] • www.generalpump.com
Ref 310157 Rev A
01-19
GENERAL PUMP A member of the Interpump Group
DFSCP12E
Flat Surface Cleaner
1. Connect directly to gun, lance or telescoping wand.
2. Turn water on and open trigger gun for flow of water through nozzles. Nozzles must have flowing spray. If
not, remove tips and clean; reassemble, making sure nozzle groove is parallel to spray bar. Use thread
sealant when installing nozzles.
3. Start pressure Washer. The flat surface cleaner is ready for operation.
4. Move the flat surface cleaner slowly across surface. If spriping occurs, slow down your pace.
5. For maximum effectiveness keep spray tips clean. If the machine vibrates, stop and clean spray tips.
6. For use with 1/4” quick disconnect, remove M22 fitting (2510103) from stem on swivel and replace with
supplied 1/4” plug. Apply thread sealant on swivel stem threads before attaching plug.
DO NOT ALLOW MACHINE TO REMAIN STATIONARY
ON SOFT SURFACES SUCH AS WOOD.
Caution: Striking any raised obstacle during operation will damage machine. If contact does occur and results in vibration when operating machine,
STOP and replace spray bar. Continued operation could result in serious injury or damage to machine.