Installation Guide

1. Loosen two 3/8" set screws in front collar (SV-28).
2. Remove front collar and slide off grip shield (SV-3).
3. Remove screws (SV-26) holding cable grippers.
4. Clean cable grippers (SV-25) or replace and re-assemble.
If your Super-Vee is not gripping the cable properly, the
cable grippers might need to be cleaned or replaced.
Changing the cable grippers is a simple job:
SV-25 CABLE GRIPPERS
C-SV25CG-0105
1. Loosen two 3/8" set screws in front collar (SV-28).
2. Remove front collar and slide off grip shield (SV-3).
3. Remove screws (SV-26) holding cable grippers.
4. Clean cable grippers (SV-25) or replace and re-assemble.
If your Super-Vee is not gripping the cable properly, the
cable grippers might need to be cleaned or replaced.
Changing the cable grippers is a simple job:
SV-25 CABLE GRIPPERS
C-SV25CG-0105
1. Loosen two 3/8" set screws in front collar (SV-28).
2. Remove front collar and slide off grip shield (SV-3).
3. Remove screws (SV-26) holding cable grippers.
4. Clean cable grippers (SV-25) or replace and re-assemble.
If your Super-Vee is not gripping the cable properly, the
cable grippers might need to be cleaned or replaced.
Changing the cable grippers is a simple job:
SV-25 CABLE GRIPPERS
C-SV25CG-0105