User Guide

Gen-Eye USB, USBW, USBP

Video Pipe Inspection/Location System

General Wire Spring Co.

1101 Thompson Avenue

McKees Rocks, PA 15136

412-771-6300 www.drainbrain.com

Bad or Grainy Picture

 Check the camera lens for dirt, grime, scratches or other foreign

matter.

 Check the Light Head to see if it is not supplying sufficient light

due to weak, dirty, or burned out bulbs.

 Check for external electrical noise being radiated by outside

sources, such as a power station, etc.

 Check the cable for possible breaks or intermittent open circuits

by flexing the cable.

 Remove the camera from the cable assembly and plug it into the

Camera Test Terminal.

 Disconnect the main power source and contact the factory ser-

vice department.

Not Recording

 Always check record and play functions prior to inspections to

ensure that the USB recorder is working properly.

 Check that there is enough memory available on the flash drive.

 Disconnect the main power source and contact the factory ser-

vice department.

FOR ALL OTHER FUNCTIONS RELATIVE TO THE SD RECORDER

OR MONITOR UNIT, PLEASE CONSULT YOUR RECORDER OR

MONITOR OWNER’S MANUAL.

Battery Won’t Hold Charge (SDP only)

 Allow 3 hours to fully charge battery.

 Cold weather can reduce battery life. Keep unit warm in cold

weather.

 Do not charge the battery in extreme weather (temperature is

below 30° F or above 104° F).

 When charging via DC, you must use an AC inverter.

 The battery charger power switch must be turned off and then

back on each time the unit is turned off or unplugged and then

turned back on or plugged back in for the charger function to

resume.

 This is a fail-safe built into the charger.

 Battery is worn out and needs to be replaced.