Specification

Flood-Guard

Prevent Basement Flooding

McKees Rocks, PA 15136 USA

800-245-6200 or 412-771-6300

www.drainbrain.com

Flood-Guard operates like a check valve to seal off water back-up

caused by overloaded sewers. Water flows normally through the

drain until the sewer begins to back up. Then the Flood-Guard

float rises to seal off the drain opening until the water recedes.

A screwdriver and a couple of minutes are all you need to

install a Flood-Guard. Once in place, it can prevent property

damage and a very messy clean-up job.

For extreme, extended pressure (for instance, where home-made

seals have popped out of the line), we recommend our standpipe

models. The 4" Standpipe Flood-Guard is threaded to receive

1-1/2" IPS pipe. On the 3" model, the pipe is slipped through the

rubber gasket before the screws are fully tightened.

Gaskets are made of molded rubber, and all metal parts are

plated or stainless steel.

Catalog Standard Weight

Number Pack Carton

2F 2" (51 mm) Float Model 4 1 lb. (.5 kg)

3F 3" (76 mm) Float Model 6 3 lbs. (1.5 kg)

4F 4" (10 cm) Float Model 6 6 lbs. (3 kg.)

S-3F 3" (76 mm) Standpipe Model 6 2-1/2 lbs. (1 kg.)

S-4FH 4" (10 cm) Standpipe Model 6 7-1/2 lbs. (4 kg.)

™

Float Model

Stand Pipe Model