Brochure

No need to drain water lines, sprinkler systems, or hot water
systems before cutting pipe or tubing. The Cold-Shot keeps
pressurized systems operating while you make repairs.
It freezes all type of liquids in steel, copper, cast iron,
aluminum and plastic pipes ranging from 1/8" to 2"
(10 mm – 60 mm) using carbon dioxide (CO
2
). Dip-tube type
cylinders are available at all welding supply houses.
The Cold-Shot is faster and less expensive than “refrigerator-
type” units; faster and uses less CO
2
than “bag-type” units. In
five minutes, you’re ready to go to work on copper tubing, just
three minutes for cast iron pipe.
Kit includes 10 sets of freeze heads
for 1/8" to 2" lines (10 mm to 60 mm),
two high pressure spiral hoses with
injectors, T-distributor, locking
nut, hex head screwdriver, rubber
gloves, goggles and carrying case.
60
Hot-Shot
Thaws Frozen Pipes Quickly
TM
®
Hit ’em High; Hit ’em Low
The Hot-Shot 400 clears longer and larger lines with
400 amps of power. It’s powerful enough to clear 1-1/2"
diameter lines up to 175 ft. long, yet weighs just 31 lbs.
Stuck on a job with only 15 amp breakers? Just flip the switch
on the Hot-Shot 400 and the amp draw drops below 14 amps
while the unit still delivers 320 amps of thawing power.
Safety features like thermal overload protection and circuit
breakers are standard equipment.
No more tearing up floors, breaking through walls, or digging
up pipes in frozen ground. Eliminate hazardous blow torches.
With the safe Hot-Shot pipe thawer, you can accomplish the job
faster and easier – and save time and money.
Easy to Operate
Just carry your Hot-Shot to the job, attach
the pipe clamps and plug it into 115 volt
receptacle. In minutes, the frozen pipe will
be flowing again.
Lighter Weight; Lower amp Draw
The Hot-Shot 320, weighing in at just 30 lbs.,
generates 320 amps of thawing power, yet draws
just 14 amps. This little unit can quickly thaw 1-1/2" diameter
lines up to 100 ft. long.
Cold-Shot
Pipe Freeze Kit